Has flotation material under the bow, all decking, and aft bench seat.
Reinforced beams across/under bow platform.
Coast Guard compliant navigation lights and accessories.
Full beam width livewell.
Reinforced side brackets near aft.
Bow mounted marine stereo speakers.
Cleats on bow and transom corners
Accessory locked storage box
Sealed battery box
Eye rings on both sides
Remote-controlled stereo with USB & Bluetooth
Boat Work Completed:
Reinforced bow eye with thick plates
Reinforced transom & transom support bar
Replaced transom interior wall with treated beams and new hdwe.
Stripped hull & applied two coats paint
Replaced all decking with 1/2” treated painted (both sides) plywood. Used almost 600 screws, placed 2” apart.
Outboard Motor Work Completed:
1986 Mercury 25HP long-shaft tiller four-stroke with new electric start kit
The motor has very low hours on it.
Just completed spark plug replacement, tune-up & maintenance
Just installed water pump rebuild kit
Just rebuilt carburetor and replaced float
Just replaced fuel filter and internal fuel line
Just replaced rod retention clips
Just replaced gearcase oil. Bearing carrier seals checked OK.
Installed lanyard kill-switch
Trailer Features/Work Completed:
1971 steel, unique, pivoting, tilt-trailer for easier loading & unloading.
Previously replaced tires (5.30-12), only 150 miles on them.
5 stud rims
Mid-frame and stop lights
Rubber side-guard rollers
Spare tire mount
Replaced all bunks & re-carpeted
Replaced bow stop-roller
Replaced hub bearings(1”)/races/seals/bearing buddy protective caps
Replaced front section of trailer with a solid beam.
Electric System Work Completed:
All wire installed in sealed electric conduit
All connections were soldered and covered with silicone
8Ga. Wire for 30A quick-connect at bow for 30lbs. thrust trolling motor
30A gold-plated circuit breaker for trolling motor circuit
100A stainless steel six circuit enclosed fuse panel
All grounds connected to gold-plated wiring block to prevent electrolysis
Bow and transom LED navigation lights.
Bow accessory power connection
Storage box with three accessory power connections
Four marine switches to control all circuits separately
Quick-disconnect battery terminal
Green LED night fishing/entertainment lighting
Accessories That Are Included:
6Gal. fuel tank (new fuel line, primer, fuel connector, vented cap)
Aerator for well
Fishfinder (can be mounted on top of storage box)
Two ratchet retention straps for securing it when trailering.
Heavy-duty trailering boat cover with engine cover, strapping, and stationary PVC upright storage supports.
Throwable Type IV flotation device and a life jacket.
Portable VHF radio
Three fold-down seats. The third seat can be mounted on the livingwell bench seat, or wherever you it mounted.
I have new outdoor carpet, if you want it for installation on the bow or a bench.
External FM radio antenna
800CCA heavy-duty deep-cycle marine battery
- Contact Person: SandroJr
- Print this ad